Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
16
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEC
OL-14518-01
Caveats
Non-Cisco Aironet Clients Sometimes Fail 802.1x Authentication
Some non-Cisco Aironet client adapters do not perform 802.1x authentication to the access point unless
you configure Open authentication with EAP. To allow both Cisco Aironet clients using LEAP and
non-Cisco Aironet clients using LEAP to associate using the same SSID, you might need to configure
the SSID for both Network EAP authentication and Open authentication with EAP.
you configure Open authentication with EAP. To allow both Cisco Aironet clients using LEAP and
non-Cisco Aironet clients using LEAP to associate using the same SSID, you might need to configure
the SSID for both Network EAP authentication and Open authentication with EAP.
Pings and Link Tests Sometimes Fail to Clients with Both Wired and Wireless
Network Connections
Network Connections
When you ping or run a link test from an access point to a client device installed in a PC running
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and
wireless connections to the LAN. Microsoft does not recommend this configuration. For more
information, refer to Microsoft Knowledge Base article 157025 at this URL:
Layer 3 Mobility Not Supported on Repeaters and Workgroup Bridges
Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.
WLSM Required for Layer 3 Mobility
You must use a Wireless LAN Services Module (WLSM) as your WDS device to configure Layer 3
mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not support Layer 3
mobility, client devices cannot associate using that SSID.
mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not support Layer 3
mobility, client devices cannot associate using that SSID.
Caveats
This section lists open and resolved caveats for access points.
Open Caveats
These caveats are open in Cisco IOS Release 12.3(8)JEC:
•
CSCsv36602—Files appearing on access point flash with 5-GHz serial number as filename
These files are created when radar is detected on a DFS channel. The files are created with the
filename consisting of the serial number of the radio that detected the radar and include the DFS
channel on which the radar was detected. The file is used is used when the access point is reset to
ensure that the radar detected channels are not immediately selected after the reset.
filename consisting of the serial number of the radio that detected the radar and include the DFS
channel on which the radar was detected. The file is used is used when the access point is reset to
ensure that the radar detected channels are not immediately selected after the reset.
Conditions: When radar is detected on a DFS channel.
Workaround: None. This is an expected behavior. The file should not be removed.