Cisco Cisco Aironet 1200 Access Point 릴리즈 노트

Ability to combine MAC-Based, EAP, and 802.11 Open Authentication.

With firmware version 11.41T, you can set up access points to authenticate client devices using a 
combination of MAC-based and EAP authentication. When you enable this feature, client devices 
that associate to the access point using IEEE 802.11 open authentication first attempt MAC 
authentication; if MAC authentication succeeds, the client device joins the network. If MAC 
authentication fails, the access point waits for the client device to attempt EAP authentication. Refer 
to the 

 in the 

Cisco Aironet 1200 Series Access Point Software Configuration Guide for more information on this 
feature.

Ability to use SNMP commands to manage firmware and configuration files.

With firmware version 11.41T, you can use SNMP object identifiers (OIDs) added to the access 
point MIB (AWCVX-MIB.my) to manage firmware and configuration files. You can find the latest 
version of the access point MIB at this URL:

The new OIDs correspond directly to buttons on the browser-based user interface. 

 lists and 

describes the new OIDs.

Ability to include a unique identifier in access point DHCP request packets.

With firmware version 11.41T, you can use the DHCP Client Identifier Value setting on the Boot 
Server Setup page to include a unique identifier in the access point’s DHCP request packet. This 
setting contains the access point’s MAC address by default, but when you select Other - Non 
Hardware from the DHCP Client Identifier Type pull-down menu, you can enter up to 255 
alphanumeric characters. See the 

 in the Cisco 

Aironet 1200 Series Access Point Software Configuration Guide for more information on this 
feature.

bootconfigCmdInvokeIniLoad 
(bootconfigCmdStatusIniLoad 
provides status for Load command)

Load Now button on the Boot 
Server Setup page; Read 
Config File From Server 
button on the System 
Configuration Setup page

Tells the access point to read an 
.ini file from the BOOTP, 
DHCP, or default file server.

awcFileXferCmdInvokeFileLoad 
(awcFileXferCmdStatusFileLoad 
provides status for Load command)

Update From Server button 
on the Update All Firmware 
From File Server page; Fully 
Update Firmware From File 
Server button on the Cisco 
Services Setup page

Tells the access point to load all 
firmware components from the 
default file server.

awcFileXferCmdInvokeFileSave 
(awcFileXferCmdStatusFileSave 
provides status for Save command)

Save to Server button on the 
Update All Firmware From 
File Server page

Tells the access point to save all 
firmware components to the 
default file server.

cmdInvokeGetWebUI 
(cmdStatusGetWebUI provides 
status for the GetWebUI command)

Load Now button on the Web 
Server Setup page

Tells the access point to load the 
auxiliary user interface pages 
specified on the Web Server 
Setup page.