Sony DVP-NC85H 사용자 설명서

F:\SONY DVD\2666954112 DVP-
NC85H_US\SOURCE\DVP-
NC85H_US\01US13ADV4-CEK.fm

master page=right

DVP-NC85H

2-666-954-11(1)

◆ AUDIO FILTER
Selects the digital filter to reduce noise above 
22.05 kHz (Sampling frequency (Fs) of the 
audio source is 44.1 kHz), 24 kHz (Fs is 
48 kHz), or 48 kHz (Fs is above 96 kHz).

There may be little effect by changing the digital 
filter depending on the disc or playback 
environment.

◆ DOWNMIX (DVD VIDEO/DVD-VR mode 
only)
Switches the method for mixing down to 2 
channels when you play a DVD which has 
rear sound elements (channels) or is recorded 
in Dolby Digital format. For details on the 
rear signal components, see “Checking the 
audio signal format” (page 44). This function 
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (OPTICAL or COAXIAL)/

HDMI OUT  jack when “DOLBY 
DIGITAL” is set to “D-PCM” (page 70).

◆ DIGITAL OUT
Selects if audio signals are output via the 
DIGITAL OUT (OPTICAL or COAXIAL)/
HDMI OUT jack.

Switches the method of outputting audio 
signals when you connect a component such 
as an amplifier (receiver) or MD deck with a 
digital input jack.
For connection details, see page 22.
Select “DOLBY DIGITAL,” “DTS,” and 
“48kHz/96kHz PCM” after setting 
“DIGITAL OUT” to “ON.”
If you connect a component that is 
incompatible with the selected audio signal, a 
loud noise (or no sound) may be heard from 
the speakers, risking damage to your ears or 
speakers.

• The AV SYNC function (page 51) is not effective 

if you use the DIGITAL OUT (OPTICAL or 
COAXIAL) jack, and set “DOLBY DIGITAL” or 
“DTS” to “DOLBY DIGITAL” or “ON” 
respectively.

• The AV SYNC function (page 51) is not effective 

if you connect a Dolby Digital or DTS-compliant 
device via the HDMI OUT jack, and set “DOLBY 
DIGITAL” or “DTS” to “DOLBY DIGITAL” or 
“ON” respectively.

SHARP

Provides a wide frequency range 
and spatial feeling.

SLOW

Provides smooth and warm 
sound.

DOLBY 
SUR-
ROUND

Normally, select this position. 
Multi-channel audio signals are 
output to 2 channels for enjoying 
surround sounds.

NORMAL

Multi-channel audio signals are 
downmixed to 2 channels for use 
with your stereo.

ON

Normally select this position. 
When you select “ON,” see 
“Setting the digital output signal” 
for further settings.

OFF

The influence of the digital 
circuit upon the analog circuit is 
minimal. If you are using the 
HDMI OUT jack, PCM sound 
will be output depending on the 
connected equipment. 
If the signal is encrypted for 
copyright protection purposes, 
the signal is only output as
48 kHz/16 bit PCM.

,