Panasonic WJ-HD200 사용자 설명서

38

● Camera Number Setup (CAM NO.

Camera numbers will be used in a PS

•

DATA chain when

you select a camera to control it from a system controller.

1. Move the cursor to CAM NO. SETUP

O with the [D] or

[C] button, and press the JogDial. The CAM NO.
SETUP menu opens.

2. Move the cursor to the desired line with the [D] or [C]

button.

3. Select the number with the JogDial, and press the

JogDial.
The default number is the same as the CAM-PORT
number.

Assignable numbers: From 001 to 128, each number

must be unique in the chain.

4. Press the [SETUP/ESC] button to go back to the SERI-

AL PORT SETUP.

■ Network Setup (NETWORK

Note: The system will restart after the menu setup window

is closed when any parameter in this window has been
changed.

● Line Speed (LINE SPEED)

1. Move the cursor to LINE SPEED with the [D] or [C]

button.

2. Select the parameter with the JogDial, and press the

JogDial.
The default is AUTO.

AUTO: The speed is automatically selected.
100M_FULL: 100 mega byte, full duplex
100M_HALF: 100 mega byte, half duplex
10M_FULL: 10 mega byte, full duplex
100M_HALF: 10 mega byte, half duplex 

● HTTP Port (HTTP PORT)

Set an HTTP port number.

The default is 80.

Available port numbers: From 00000 to 65535, except

the "well-known port" numbers assigned by IANA
(Internet Assigned Numbers Authority)

● Dynamic Host Configuration Protocol

Dynamic Host Configuration Protocol is enabled or dis-
abled.

The default is OFF.

Note: When ON is selected, you cannot enter the IP

address, netmask, or gateway. The host gives these
parameters.
The given parameters will be displayed after getting
the IP address from the DHCP server.

→   00080

→192.168.000.010

→255.255.255.000

→192.168.000.001