Troy-Bilt series 650 사용자 설명서

Using two 

2. 

5⁄16”-18 x 1-3⁄4” screws and 5⁄16”-18 hex nuts, loosely 

attach the handlebar support using the upper holes. 

Tighten the two screws securely. See Fig. 3-2.

There are three height adjustment holes in the two handlebar 

3. 

support brackets. Use a setting that will position the 

handlebars at approximately waist level when the tines are 

3-4” into the soil. Loosely attach the support brackets to 

the outside of the handlebar assembly using two 5⁄16”-18 x 

1-3⁄4” screws and 5⁄16”-18 hex nuts. Refer to Fig. 3-2. 
NOTE: If a support bracket will not move, loosen attaching 

screw and nut.
NOTE: The support brackets must be assembled to the 

outside of the handlebar assembly.
Tighten all the handlebar mounting hardware securely.

4. 

To roll the tiller off the shipping platform, put the wheels in 

freewheel, as follows: 

Place a sturdy block under the transmission to raise one 

1. 

wheel about 1” off the ground.
Remove the click pin from the wheel hub and wheel shaft. 

2. 

See Fig. 3-3.

Slide the wheel fully inward on the wheel shaft . Reinstall the 

3. 

click pin through the wheel shaft only (not through the 

wheel hub). See Fig. 3-3. The wheel should now spin freely 

(freewheel) on the wheel shaft. Repeat with the other 

wheel.
Use the handlebar to roll the tiller to a flat area.

4. 
NOTE: Before starting the engine, the wheels must be placed in 

the WHEEL DRIVE position (pins through wheel hubs and wheel 

shaft).