Troy-Bilt series 650 사용자 설명서

Carefully unwrap the reverse clutch cable (Red) from its 

1. 

shipping position. Pull the cable up through the top hole 

in the cable bracket and push the cable connector up 

through the hole in the bracket until the groove in the 

connector snaps into place. See Fig. 3-4.

NOTE: Be sure to select the cable marked with red and be 

sure that the reverse cable is placed into the top hole in the 

cable bracket.
Place the Z-connecter into the hole in the reverse clutch 

2. 

control. See Fig. 3-4.

Carefully unwrap the forward clutch cable (Black) from its 

1. 

shipping position. Pull the cable up through the bottom 

hole of the cable bracket and push the cable connector 

up through the hole in the bracket until the grove in the 

connector snaps into place. See Fig. 3-4.
NOTE: Be sure to select the cable marked with black and be 

sure the forward cable is placed into the bottom hole in the 

cable bracket.
Place the Z-connector into the hole in the forward clutch 

2. 

bail. See Fig. 3-4.

Check the air pressure with a tire guage. Deflate or inflate the 

tires equally to between 15 and 20 PSI. 
NOTE: Be sure that both tires are inflated equally or the tiller will 

pull to one side.

Use extreme care when handling 

gasoline. Gasoline is extremely flammable and the 

vapors are explosive. Never fuel the machine 

indoors or while the engine is hot or running. 

Extinguish cigarettes, cigars, pipes and any other 

sources of ignition.

Service the engine with gasoline and oil as instructed in the 

Engine Operator’s Manual packed seperately with your tiller. 

Read the instructions carefully.