RadioFrame Networks Inc RFU7 사용자 설명서
Installing the RadioFrame System
17
Connect the ACU to the NCU and the ACU to the RFUs
1
Connect Port 1 on the front of the ACU to the specified port on the back of the
NCU using an RJ45-to-RJ45 CAT 5 cable.
NCU using an RJ45-to-RJ45 CAT 5 cable.
2
Verify that the ACU is connected to the NCU.
The Link and Activity LEDs above Port 1 should both light green, and the
Activity LED should blink rapidly indicating that the connection to the NCU is
operating. If the LEDs do not come on, refer to “Troubleshooting.”
The Link and Activity LEDs above Port 1 should both light green, and the
Activity LED should blink rapidly indicating that the connection to the NCU is
operating. If the LEDs do not come on, refer to “Troubleshooting.”
3
Connect each RFU to the specified port (1-8) on the back of the ACU using RJ45-
to-RJ45 CAT 5 patch cables.
The Link and Activity LEDs above each RFU port will remain unlit until each
RFU has been installed.
to-RJ45 CAT 5 patch cables.
The Link and Activity LEDs above each RFU port will remain unlit until each
RFU has been installed.
Figure 9
Connect Port 1 on the front of the ACU to the specified port on the
back of the NCU, and Ports 1 through 8 on the back of the ACU to
each RFU.
back of the NCU, and Ports 1 through 8 on the back of the ACU to
each RFU.