Netgear 14100256 사용자 설명서

When the router is turned on, the Power LED 

 turns amber for about 20 seconds and 

then turns green. If the LED does not turn green, the router has a problem.

If the Power LED is still amber one minute after you turn on power to the router, try the 
following:

Unplug the router’s power adapter cord. Plug it in again and see if the router recovers.

To return the router to its factory settings, press and hold the Reset button. 

If the error persists, you might have a hardware problem. Contact technical support at 

If the Internet LED 

 does not light, check the following:

Make sure that the Ethernet cable is securely connected to the router Internet port and 
the modem.

Make sure that power is turned on to the connected modem.

Be sure that you are using the correct cable.

When you connect the router’s Internet port to a cable or DSL broadband modem, use 
the cable that was supplied with the cable or DSL broadband modem. This cable can be 
a standard straight-through Ethernet cable or an Ethernet crossover cable.

If the WiFi LED 

 stays off, check to see if someone disabled the wireless radio or set up a 

68. The WiFi LED is lit when the wireless radio is turned on.

If you cannot log in to the router from a computer or wireless device on your local network, 
check the following:

Make sure that your computer or wireless device is connected to the router’s network.

For a WiFi connection, select the network and entered its WiFi password.

For a wired connection, use an Ethernet cable to connect your computer to an 
Ethernet LAN port on the router (not the Ethernet Internet port).

Launch a web browser from a computer or wireless device that is connected to the network.

In the address field of your browser, type www.routerlogin.net or www.routerlogin.com.

If a login prompt does not display, try the following:

DRAFT