Microsoft Corporation CU-13R 사용자 설명서

• Connect the female connector of the ISO cable to the power and 

speaker connectors of the car wiring harness.

• Check the permanent +12 V feed (red wire) and ignition feed 

(blue wire) on the junction box connector. If necessary, swap the 
configuration connectors "+12V battery" and "Ignition" of the 
ISO cable.

Check the correct location of the mute signal for the car radio, 
and connect the configuration connector "Mute" to the 
corresponding socket (Mute1, Mute2, or Mute3). By default, the 
mute connector is connected to the ISO connector pin A2 
(Mute2). If the car radio does not support the mute function, 
leave the connector unconnected.

Plug the two ISO male connectors to the car radio.

2. Insert the speaker and power cable plugs of the ISO cable to the 

respective connectors on the junction box.

3. Connect the display to the respective connector on the junction box.

Optional steps:

• To charge a compatible mobile device through the car kit, connect a 

compatible charging cable (such as Nokia CA-159) to the junction 
box.

• To use an external microphone (such as Nokia MP-2) instead of the 

built-in one, connect the microphone to the respective connector on 
the junction box, and modify the microphone settings (see “Installer 
settings”, p. 36). In noisy car environments, you may need to use an 
external microphone.