Nokia Solutions and Networks T5DK1 사용자 설명서
Earth Ground Cabling
68P64115A19
–
4
Mar 2003
1X SC 4812T-MC BTS Hardware Installation - Software Release R2.16.1.x
CONTROLLED INTRODUCTION
2-41
Install Earth Grounding Cables
WARNING
S
Do NOT wear a wrist strap when servicing the power
supplies or power distribution cabling! Serious personal
injury can result.
supplies or power distribution cabling! Serious personal
injury can result.
S
Before starting the procedure, ensure that the BTS power
cables are not connected to the main DC source.
cables are not connected to the main DC source.
Table 2-33: Procedure to Install Earth Grounding Cables
Step
Action
1
Route the ground cables (cable N) between the Master
Ground Bar (MGB) and the BTS frames.
Ground Bar (MGB) and the BTS frames.
NOTE
Ground cables must not have sharp bends.
2
Strip insulation from the BTS end of each cable.
3
Attach a ring lug to the BTS end of each cable.
4
Connect a ground cable (cable N) to the ground stud of each
BTS frame.
BTS frame.
5
Connect the ground lugs to directional coupler bracket,
duplexer bracket, and RFDS (if used).
duplexer bracket, and RFDS (if used).
6
Attach the ground cables to the MGB using the appropriate
connectors.
connectors.
2