Uniden America Corporation UB315 사용자 설명서
Another method is as follows:
1. Press HOLD/MAN.
2. While the setting for VFO is a channel,
rotate the VFO until the desired
channel is displayed. The scanner will
automatically go to hold mode.
channel is displayed. The scanner will
automatically go to hold mode.
Storing Frequency
During Scanning
1. Press HOLD/MAN.
2. Press TRANSFER, and the empty channel number
appears on the display.
3. Press E.
Note: If you want to change the channel, rotate VFO.
RF Attenuation Feature
The BC250D comes with an RF Attenuation feature. If you're
near an unusually strong signal source, the signal may
overload the scanner. The scanner may stop repeatedly on
that signal and miss other transmissions.
near an unusually strong signal source, the signal may
overload the scanner. The scanner may stop repeatedly on
that signal and miss other transmissions.
The RF Attenuation feature works in all modes and attenuates
(reduces) the incoming signal strength to prevent stronger
signals from overloading the scanner.
(reduces) the incoming signal strength to prevent stronger
signals from overloading the scanner.
The RF attenuation is set at the menu mode.
1. Press MENU/BACK.
2. For Search mode, select
SERVICE OPTION
-
CHAIN
SEARCH
-
ON
- by rotating the VFO and pressing E.
OR
For Scan mode, select
SCAN OPTION
-
CONVENTIONAL
by rotating the VFO and pressing E.
Then select the channel number by rotating the VFO and
pressing E.
pressing E.
3. Select
ATTENUATOR
by rotating the VFO and pressing
E.
4. Set to
ON
by rotating the VFO and then press E.
Note: Attenuation will only be active for the specified
channel. In Search mode, it is applied to the search
ranges.
ranges.
32
HOLD/
MAN
SCAN
CH/
FRQ
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
BC250D 9/20/2 2:52 PM Page 32