Uniden America Corporation UB315 사용자 설명서
Lockout in Scanning Mode
If the scanner keeps stopping on a particular channel due to
noise or too frequent transmissions, you may want to keep
that channel from scanning.
noise or too frequent transmissions, you may want to keep
that channel from scanning.
1. Wait until the scanner stops at the
channel.
2. Then press L/O.
3. The scanner immediately resumes
scanning because the locked out
channel is no longer in the scanning
sequence.
channel is no longer in the scanning
sequence.
Lockout Tips
Write down your locked-out channels and
put in a convenient place in case you need
to restore them.
put in a convenient place in case you need
to restore them.
Restoring a Locked-out Channel
1. Press HOLD/MAN.
2. Select a locked out channel.
a. Enter the channel number using the keypad.
b. Then press HOLD/MAN again.
b. Then press HOLD/MAN again.
3. Press L/O to unlock the channel. The
L/O
icon
disappears.
Restoring All Locked-out Channels
You can restore all locked-out channels in a bank only when a
bank is selected for scan. If you have deselected a bank and
you want to restore all of its locked-out channels using the
steps below, you must press SCAN and then enter the
number of the bank on your keypad.
bank is selected for scan. If you have deselected a bank and
you want to restore all of its locked-out channels using the
steps below, you must press SCAN and then enter the
number of the bank on your keypad.
1. Press HOLD/MAN.
Note: You must be in Hold mode before
restoring all locked-out channels.
2. Press and hold L/O for about
2 seconds.
You will hear a confirmation tone
when all the channels have been
restored.
You will hear a confirmation tone
when all the channels have been
restored.
34
C 001
141.5000 NFM
141.5000 NFM
25cm Amateur Grp
C 001
SCAN
Bank 1234567890
SCAN
Bank 1234567890
HOLD/
MAN
SCAN
CH/
FRQ
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
SERVICE
BC250D 9/20/2 2:52 PM Page 34