Texas Instruments DLP® LightCrafter™ Evaluation Module DLPLIGHTCRAFTER DLPLIGHTCRAFTER 데이터 시트

제품 코드

DLPLIGHTCRAFTER

Upgrading Firmware

www.ti.com

Figure 2-54. DLP LightCrafter GUI Camera Tab

2.13 Upgrading Firmware

Periodic upgrades to the firmware of the FPGA, DLPC300, MSP430, and EDID are accomplished through
the DLP LightCrafter GUI. To upgrade the DM365 firmware, a micro-SD card with the new software is
needed to load the software into the NAND flash.

2.13.1 Updating the MSP430, FPGA, DLPC300, or EDID using the GUI

To upgrade the FPGA, DLPC300, MSP430, or EDID, perform the following steps:

1. Select the "Solution / Splash" and "Firmware Upgrades" tabs as shown in

Figure 2-55

Operating the DLP LightCrafter

DLPU006C – January 2012 – Revised December 2013

Submit Documentation Feedback