Texas Instruments DRV8313 Evaluation Module DRV8313EVM DRV8313EVM 데이터 시트
제품 코드
DRV8313EVM
RUNNING THE APPLICATION
4
RUNNING THE APPLICATION
For future use, the application can be opened from the following path: Start
→
All Programs
→
Texas
Instruments Inc.
→
DRV8313EVM
4.1
Connecting the Hardware to GUI
Once the application 'DRV8313EVM' is opened, it tries to connect to the hardware. During this attempt the
connection status indicator starts blinking at the rate of ~1 sec.
connection status indicator starts blinking at the rate of ~1 sec.
Figure 6. Status Indicator
•
If the Indicator starts blinking with green and light green in color, the connection is established between
the hardware and GUI.
the hardware and GUI.
•
If the Indicator starts blinking with green and red in color, the connection attempt is still going on. This
attempt will continue for 10 seconds after which the communication error will be indicated as below
where the ‘Retry’ option will be visible.
attempt will continue for 10 seconds after which the communication error will be indicated as below
where the ‘Retry’ option will be visible.
If the connection could not be established please check for the following.
•
The EVM is power is present.
•
FTDI drivers are installed.
•
The reset jumper (JP2) and 3V3 (JP1) jumper is in place.
•
The connection cable between the PC and Hardware is connected.
8
DRV8313EVM User’s Guide
SLVU815 – November 2012
Copyright © 2012, Texas Instruments Incorporated