Texas Instruments Multi-Cal-System Basic Starter Kit MULTI-CAL-SYSTEM MULTI-CAL-SYSTEM 데이터 시트
제품 코드
MULTI-CAL-SYSTEM
IEEE488 card
National Instruments
GPIB-USB-HS
Starter System Setup
shows how to connect the IEEE488 to the DMM. The software for the Multi-Cal-System requires
the National Instruments GPIB-USB-HS. This option is also used for remote control of the instrument. In
order to use this capability, you must set the DMM to IEEE488 mode, and set the address according to
the control script (default = 3). An optional way to communicate with the DMM is through the RS-232 port
on your computer.
order to use this capability, you must set the DMM to IEEE488 mode, and set the address according to
the control script (default = 3). An optional way to communicate with the DMM is through the RS-232 port
on your computer.
Figure 19. Connect IEEE488 to DMM
20
Multi-Cal-System Evaluation Module
SBOU087A
–
August 2010
–
Revised April 2011
Copyright
©
2010
–
2011, Texas Instruments Incorporated