Texas Instruments Multi-Cal-System Basic Starter Kit MULTI-CAL-SYSTEM MULTI-CAL-SYSTEM 데이터 시트
제품 코드
MULTI-CAL-SYSTEM
USB DAQ: Generates
signals and controls
Interface boards:
Sensors connect here
Master and
Slave Mux
DMM and
power supply
Replace with
1.25-inch standoff
Remove
0.25-inch standoff
Expanding the System Size
shows the complete Multi-Cal-System setup. At this point, the system is fully connected and you
are ready to run the software.
Figure 22. Complete System Setup
3
Expanding the System Size
The Multi-Cal-System can be expanded by adding Multi-Cal-Slave boards. Each Multi-Cal-Slave board
adds eight additional channels. The maximum system size is 64 channels (one master and seven slaves).
The first step in expanding the system size is to remove the 0.25-inch standoffs and replace them with
1.25-inch standoffs; this step is shown in
adds eight additional channels. The maximum system size is 64 channels (one master and seven slaves).
The first step in expanding the system size is to remove the 0.25-inch standoffs and replace them with
1.25-inch standoffs; this step is shown in
.
Figure 23. Replace Standoffs
22
Multi-Cal-System Evaluation Module
SBOU087A
–
August 2010
–
Revised April 2011
Copyright
©
2010
–
2011, Texas Instruments Incorporated