Tandberg Data StorageLibrary T40+, 24 slots, 1xLTO-3 8136-LTO 사용자 설명서
제품 코드
8136-LTO
StorageLibrary Installation and User Guide
43
If there is at least one unassigned drive and one unassigned magazine, the wizard asks if the user
wants to configure another partition. If yes, then repeat the steps for partition setup. If no, the user
receives a warning that there are unassigned resources in the library.
wants to configure another partition. If yes, then repeat the steps for partition setup. If no, the user
receives a warning that there are unassigned resources in the library.
The partitions are configured with the Setup Wizard. If you later want to change your partition
configuration, you can either re-run the Setup Wizard or access the partition configuration screens
directly:
configuration, you can either re-run the Setup Wizard or access the partition configuration screens
directly:
•
From the RMI, select Setup > Partition/Drive
•
From the FPI, select Setup > Partitions
Re-configuring Partitions
You may later need to re-configure your partition setup if the number of cleaning slots or the I/E slot
configuration are changed, or if you need to split the library into a larger og smaller number of
partitions.
configuration are changed, or if you need to split the library into a larger og smaller number of
partitions.
Note
Exporting all cartridges already assigned to the partitions is recommended before
you reconfigure your partition.
you reconfigure your partition.
It is not possible to edit your partition setup. If you choose to re-configure your partition setup from
the front panel interface, the old setup will be deleted.
the front panel interface, the old setup will be deleted.
If you choose to re-configure your partition setup from the remote management interface and your
current partition configuration has used all available resources, you will need to remove at least one
partition. The resources from the deleted partition(s) can then be allocated to the remaining
partition(s).
current partition configuration has used all available resources, you will need to remove at least one
partition. The resources from the deleted partition(s) can then be allocated to the remaining
partition(s).
The appropriate screens to re-configure your partition setup are:
•
From the RMI, select Setup > Partition/Drive
Use the “next” button in the setup to move to the last partition. Use the “remove partition” button to
remove the partition. Remove as many partitions as you want to, and then allocate the
drives/magazines from the deleted partitions to the remaining or new partitions.
Use the “next” button in the setup to move to the last partition. Use the “remove partition” button to
remove the partition. Remove as many partitions as you want to, and then allocate the
drives/magazines from the deleted partitions to the remaining or new partitions.
•
From the FPI, select Setup > Partition
Changing Partition Modes
The library has two partition modes, Online and Offline.
Note
When changing the partition mode from online to offline, all host application
commands are completed if they are in progress when the mode is changed.
commands are completed if they are in progress when the mode is changed.
•
Online — the normal operating condition for the partition. In this mode, the robotics is enabled and
all host application commands are processed.
all host application commands are processed.
•
Offline — the partition does not process any host application commands. If a partition is taken
offline, the physical library and other partitions are not affected.
offline, the physical library and other partitions are not affected.
The library is automatically taken offline when the unit is busy executing internal time consuming
tasks.
tasks.
In addition, the user can manually take the physical library, or any of its partitions, online or offline.
You can take a partition offline rather than the entire library so as to minimize disruption of library
operations. You may manually change the partition mode to online or offline from the front panel or
from the remote management interface.
You can take a partition offline rather than the entire library so as to minimize disruption of library
operations. You may manually change the partition mode to online or offline from the front panel or
from the remote management interface.
Details on changing partition mode include:
•
The default partition mode is online.