Tandberg Data StorageLibrary T40+, 24 slots, 1xLTO-3 8136-LTO 사용자 설명서
제품 코드
8136-LTO
StorageLibrary Installation and User Guide
45
Modifying the Control Path
The control path tape drive is used to connect a partition to a host application. For normal operation,
only one tape drive should be selected as the control path for each partition at any one time. By
default, the lowest tape drive assigned to a partition is designated the control path. In the event that
the control path connection to the host application fails, you may manually select a new control path
for the partition.
only one tape drive should be selected as the control path for each partition at any one time. By
default, the lowest tape drive assigned to a partition is designated the control path. In the event that
the control path connection to the host application fails, you may manually select a new control path
for the partition.
Note
You may need to modify settings in your host application as a result of modifying
the control path. For details, please refer to your host application documentation.
the control path. For details, please refer to your host application documentation.
The control path is configured with the Setup Wizard. After the initial setup of your library you can later
access the control path configuration screens directly:
access the control path configuration screens directly:
•
From the RMI, select Setup > Partition/Drive
•
From the FPI, select Setup > Partitions
Configuring Menu Time-out
The Menu Timeout feature allows you to configure the timeout delay on the front panel and remote
management interface. If there has been no activity on the front panel or remote management
interface for a specified time, the FPI and RMI screens return to the home screens. The menu timeout
is user settable from 1 to 9 minutes. The default value is 1 minute.
management interface. If there has been no activity on the front panel or remote management
interface for a specified time, the FPI and RMI screens return to the home screens. The menu timeout
is user settable from 1 to 9 minutes. The default value is 1 minute.
The menu timeout is configured with the Setup Wizard. After the initial setup of your library you can
later access the Menu Timeout configuration screens directly:
later access the Menu Timeout configuration screens directly:
•
From the RMI, select Setup > Library
•
From the FPI, select Setup > Library
Setting Date and Time
The library is equipped with a battery backed up real time clock. The time is set initially during
manufacturing, but needs to be re-set to the local time by the user. As a minimum, it is recommended
that the library’s date and time be set during initial configuration. The settings are used to log the date
and time that events have taken place. The library date and time settings can be modified at any time.
manufacturing, but needs to be re-set to the local time by the user. As a minimum, it is recommended
that the library’s date and time be set during initial configuration. The settings are used to log the date
and time that events have taken place. The library date and time settings can be modified at any time.
The time is set to a 24 hour clock. For example, four o’clock in the afternoon is entered as 16:00.
The Date & Time is configured with the Setup Wizard. After the initial setup of your library you can
later access the Date & Time configuration screens directly:
later access the Date & Time configuration screens directly:
•
From the RMI, select Setup > Library
•
From the FPI, select Setup > Library
Configuring Barcode Scan
This feature allows the operator to enable or disable the barcode scanner from the front panel or the
remote management interface. The default setting for the library is “barcode scanner enabled”. If
disabled, the library will locate cartridges using the robotics.
remote management interface. The default setting for the library is “barcode scanner enabled”. If
disabled, the library will locate cartridges using the robotics.
The Barcode Scan is configured with the Setup Wizard. After the initial setup of your library you can
later access the Barcode Scan configuration screens directly:
later access the Barcode Scan configuration screens directly:
•
From the RMI, select Setup > Library