Sony Water Dispenser 2 사용자 설명서
Chapt
er
16
Eng
inee
ring
S
e
S
e
tu
p
200
Setup for the Whole System
Selecting the state at start-up
Use the following procedure.
1
In the status area of the System>Start Up menu, select the device to which
the settings are to apply.
the settings are to apply.
2
In the <Start Up Mode> group, select one of the following modes.
Resume: When this is on, Resume mode is enabled.
Custom: When this is on, Custom mode is enabled.
Custom: When this is on, Custom mode is enabled.
For information about Resume mode and Custom mode, see “System
Setup” in Chapter 1 (Volume 1).
Setup” in Chapter 1 (Volume 1).
Note
The Resume mode is only valid when a switcher or control panel is
selected for the setting. In this case, the initial status of the control panel
applies only to the key bus delegation button settings.
selected for the setting. In this case, the initial status of the control panel
applies only to the key bus delegation button settings.
3
When Custom mode is selected, in each of the <Setup> group and <Initial
Status> group, select one of the following.
Status> group, select one of the following.
User: When this is on, user-defined settings are used for the Setup or
Initial Status settings. For the method of saving the user-defined
settings, see the next item.
settings, see the next item.
Factory: When this is on, factory default settings are used for the Setup or
Initial Status settings.
4
To confirm the settings, press [Execute]. If you want to cancel the setting
changes without saving them, press [Clear].
changes without saving them, press [Clear].
When [Execute] is pressed, a confirmation message appears.
5
Select [Yes].
The start-up state settings are saved.
Saving user-defined settings
To save the Setup settings
Use the following procedure.
1
After selecting the devices the settings apply to, in the System>Start Up
menu, press [Setup Define].
menu, press [Setup Define].
A confirmation message appears.