Technics SL-C700 작동 가이드
16
When other equipment responds to the supplied remote
control, change the remote control code.
control, change the remote control code.
≥ The factory default is “Mode 1”.
≥ Only available from the SU-C700/ST-C700 remote control:
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
and hold [OK] and the numeric button for at least
4 seconds.
≥ When the remote control code is changed, the new code
will appear on the display for a few seconds.
≥ When the SU-C700/ST-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
control code for this unit.
Select English or French for the display.
≥ The factory default is “English”.
≥ Operation with the touch panel on the unit:
1
Touch [MENU] repeatedly to select “Setup”
and then touch [1/;].
and then touch [1/;].
2
Touch [MENU] repeatedly to select
“Language”.
“Language”.
3
Touch [:, 9] to select “English”/
“Français” and then touch [1/;].
“Français” and then touch [1/;].
4
Touch [∫] twice after you have finished
setting.
setting.
≥ Operation with the SU-C700/ST-C700 remote control:
1
Press [CD].
2
Press [MENU].
3
Press [3, 4] repeatedly to select “Setup”
and then press [OK].
and then press [OK].
4
Press [3, 4] repeatedly to select
“Language”.
“Language”.
5
Press [2, 1] to select “English”/“Français”
and then press [OK].
and then press [OK].
6
Press [MENU] after you have finished
setting.
setting.
You can automatically link this unit with SU-C700 to operate
them.
them.
Preparation
1 Connect this unit and the SU-C700 with a system
1 Connect this unit and the SU-C700 with a system
connection cable and a coaxial digital cable. (> 9)
2 Set the power switch lever of this unit and the SU-C700
to the [Í/I] position.
∫ Switching this unit and the SU-C700 to
on/standby simultaneously
≥ When this unit and SU-C700 are in standby mode, while
pointing the SU-C700/ST-C700 remote control at this unit,
press [CD Í] so that this unit and SU-C700 switch on
automatically.
press [CD Í] so that this unit and SU-C700 switch on
automatically.
∫ Switching the SU-C700’s input source
automatically
When you perform an operation such as playback on this
unit, the input source of the SU-C700 will be automatically
switched to “COAX2”.
unit, the input source of the SU-C700 will be automatically
switched to “COAX2”.
≥ For information on the operations of the SU-C700, please also
refer to its operating instructions.
Remote control code
[OK] + [1]
Set the code to “Mode 1”
[OK] + [2]
Set the code to “Mode 2”
Language
Using the system control
function
function
(16)
SL-C700-SQT0934.book 16 ページ ２０１５年３月２４日 火曜日 午後５時３３分