Nuance comm Server D60709-22 사용자 설명서
3 SafeCom Controller
D60709-22
44
High Speed Print Enabled should be YES to allow faster printing. With high
speed print the print speed becomes comparable to that of printing the
document directly to the device. High Speed Print works without any
drawbacks in environments where users are only Pull Printing.
Note: With High Speed Print enabled, Push prints are deleted if they arrive at
the device while a user is logged in.
Post Tracking will cause tracking data to be adjusted to reflect the actual
number of mono and color pages printed.
Note: When Post Tracking is enabled AND a user is logged in at the MFP, all
jobs that are sent directly to the Sharp MFP are deleted.
Drivers. When Pull Printing SafeCom will compare the driver name embedded
in the print job with its list of driver names. If no match is found the document
will appear with a question mark [?] in the document list. This way the user is
warned that fidelity is low and the document may print incorrectly.
speed print the print speed becomes comparable to that of printing the
document directly to the device. High Speed Print works without any
drawbacks in environments where users are only Pull Printing.
Note: With High Speed Print enabled, Push prints are deleted if they arrive at
the device while a user is logged in.
Post Tracking will cause tracking data to be adjusted to reflect the actual
number of mono and color pages printed.
Note: When Post Tracking is enabled AND a user is logged in at the MFP, all
jobs that are sent directly to the Sharp MFP are deleted.
Drivers. When Pull Printing SafeCom will compare the driver name embedded
in the print job with its list of driver names. If no match is found the document
will appear with a question mark [?] in the document list. This way the user is
warned that fidelity is low and the document may print incorrectly.
3.4
SafeCom Go for Controller - How to
3.4.1
Enable copy tracking for Controller
Copy tracking is disabled by default. To enable it, follow these steps:
1.
1.
Open the Printer web page (3.3.4).
2.
Change Copy Enabled to YES.
3.
Click Save and Continue.
4.
Click Restart.
3.4.2
Specify SafeCom Server and device connection
1.
Open the Advanced Configuration web page (3.3.2).
2.
Click SafeCom (3.3.3) and enter the SafeCom Server address (Hostname
or IP address). It is possible to specify multiple SafeCom servers for the
purpose of failover. The SafeCom Controller will attempt to contact the
servers in their order of appearance. If the SafeCom server is clustered
you must specify the address of the virtual server. Click Save and
Continue.
or IP address). It is possible to specify multiple SafeCom servers for the
purpose of failover. The SafeCom Controller will attempt to contact the
servers in their order of appearance. If the SafeCom server is clustered
you must specify the address of the virtual server. Click Save and
Continue.
3.
Click Printer and check Network – Port 9100.
Enter the Printer IP address.
Enter the Printer IP address.
4.
Click Save and Continue.
5.
Click Restart.
After approx. 1 minute the SafeCom Controller has restarted and you can make
a setting printout.