Wacom DTU-710 사용자 설명서

● No display. The power LED is off. ■ Check that the AC power adaptor is plugged into both the 

pen display tablet and an active power outlet, and that the 
DTU-710 power switch is turned on.

● No display. The power LED is lit 

blue.

■

Check the contrast, brightness, and backlight cntrols.Adjust 

as necessary, or open the OSD menu, go to the RESET menu 
and select the RECALL option.

● The image appears multiple times 

on the display.

■

Do not extend the video signal cable. Do not use an input 

selector switch box.

● When a still image is displayed 

for a long period of time without 
refreshing the screen, an afterimage 
remains for a short period of time.

■

 Use a screen saver or other power management feature.

● The color white does not display as 

white.

■

Verify that the display is operating at the factory default 

settings. If that is not sufficient, then adjust color as necessary. 
For details on color management, refer to your operating 
system and application documentation.

■

 Verify that the video cable and connector are fully connected.

● The display ripples or flickers.

■

Open the OSD menu, go to the RESET menu, and select the 

AUTO ADJUST option. Then, if necessary, manually adjust 
pitch and phase.

■

 Verify that the display adaptor or video card matches the 

specifications for the DTU-710.

■

Adjust the refresh rate in the Display Properties control 

panel.

● The display is not clear.

■

As necessary, adjust contrast or brightness, pitch and phase.

■

 Set the display resolution of your video card to 1280 x 1024.

● The display and LCD panel are not 

lined up. The display size is not 
correct.

■

Open the OSD menu, go to the RESET menu, and select the 

RECALL option.

■

 As necessary, adjust pitch and phase, and horizontal and 

vertical position. Note that some video cards may not show 
the display in proper sizing.

● The display ripples or shows a 

moire pattern. The display color is 
not even.

■

 Open the OSD menu, go to the RESET menu, and select the 

RECALL option.

■

 As necessary, adjust PITCH and PHASE. ☞ P.24