Wacom DTU-710 사용자 설명서

● The computer does not have an 

available USB port.

■

Check if there is an available USB port on a USB hub. If 

none are available, you will need to add a USB hub or USB 
card.

● The tablet power LED is off.

■

Make sure the pen display tablet power switch is turned on.

■

 Check that the AC power adaptor is plugged into both the pen 

display tablet and an active power outlet.

■

 Always be sure to use only the power adaptor that came with 

the pen display tablet; other adaptors may cause damage to 
your product.

● The pen works only in mouse 

mode, and does not draw with 
pressure sensitivity.

■

The tablet driver software was not installed or did not load 

properly.

■

Make sure the tablet driver software is installed and functioning.

■

Install the driver software for the pen tablet in accordance 

with the instructions found in the Installation section of this 
manual.

● The pen selects everything or will 

not stop drawing.

■

 Open the tablet control panel and go to the PEN tab.

 

Move the TIP FEEL slider toward FIRM.

● Double-clicking is difficult.

■

Be sure you are quickly tapping the display screen twice 

in the same place on the pen display tabletʼs active area. 
Using the side switch (when equipped) to double-click is a 
recommended method.

■

 Try increasing the DOUBLE-CLICK DISTANCE.

■

 Try using a lighter TIP FEEL.

 

Windows: You might also consider turning on the Web style 

interface so that you can navigate using a single click of the 
pen.

● The eraser selects everything or 

will not stop erasing.

■

 Open the tablet control panel and go to the PEN tab. Move 

the ERASER FEEL slider toward FIRM.

● There is a delay at the beginning of 

pen strokes when using the pen for 
drawing or selecting.

■

Try decreasing the DOUBLE-CLICK DISTANCE.

● The pen tip does not function.

■

Be sure you are using the pen (modelUP-911E) that originally 

came with your pen display tablet. Other pens may not 
function properly on the DTU-710 pen display tablet.

■

 Make sure the status LED lights blue when the tip is pressed.

Verify also that the USB cable is plugged in; the LED will not 
light if the USB cable is not plugged into an active port. If the 
LED does not light, you may have defective hardware.