Teledyne MODEL T703 Manual Do Utilizador
Teledyne API T703 Calibrator Operation Manual
Getting Started
33
3.2.4. CONNECTING THE CONTROL INPUTS
The calibrator is equipped with 12 digital control inputs that can be used to Initiate various user programmable
calibration sequences (see Section 6.5.1.5 for instructions on assigning the control inputs to specific calibration
sequences).
calibration sequences (see Section 6.5.1.5 for instructions on assigning the control inputs to specific calibration
sequences).
Access to these inputs is via 2 separate 10-pin connectors, labeled CONTROL IN, that are located on the
calibrator’s rear panel.
calibrator’s rear panel.
Table 3-4: T703 Control Input Pin Assignments
CONNECTOR INPUT
DESCRIPTION
Top
1 to 6
Can be used as either 6 separate on/off switches or as bits 1 through
6 of a 12 bit wide binary activation code (see Section 6.5.1.5)
6 of a 12 bit wide binary activation code (see Section 6.5.1.5)
Bottom
7 to 12
Can be used as either 6 separate on/off switches or as bits 7 through
12 of a 12 bit wide binary activation code (see Section 6.5.1.5)
12 of a 12 bit wide binary activation code (see Section 6.5.1.5)
BOTH
Chassis ground.
Top U
Input pin for +5 VDC required to activate pins A – F. This can be from
an external source or from the “+” pin of the instruments STATUS
connector.
an external source or from the “+” pin of the instruments STATUS
connector.
Bottom U
Input pin for +5 VDC required to activate pins G – L. This can be from
an external source or from the “+” pin of the instruments STATUS
connector.
an external source or from the “+” pin of the instruments STATUS
connector.
BOTH
+
Internal source of +5V that can be used to actuate control inputs when
connected to the U pin.
connected to the U pin.
07223B DCN6378