Hunter Fan 42737-01 Manual Do Utilizador

Hunter Fan Company 

42737-01 • 11/14/06 

42737-01 • 11/14/06 

Hunter Fan Company

5-1.  Holding the canopy, raise the fan off  the hook.

5-2.  Align the slots in the canopy with the tabs on the ceiling plate.

5-3.  Raise the canopy over the ceiling plate. Rotate the canopy 

clockwise until the tabs on the ceiling plate totally engage with 
the slots in the canopy.

5-4.  Partially install the three canopy screws into the canopy one at a 

time. Once all three screws are in, tighten them.

5-5.  Using both hands, push the canopy trim ring up to the top of the 

canopy. Th

  e canopy trim ring will snap and lock into place.

  1.  Locate the tab indicators, small 

bumps on top of tabs.

  2.  Press fi rmly on opposite sides of the 

ring towards the canopy. Th

 e tabs 

will fl ex out releasing the trim ring 
from the canopy.

Canopy Trim 

Ring

Canopy

Ceiling Plate

Canopy 

Screw

Hunter fans use several styles of fan blade irons (brackets that hold the 
blade to the fan).

6-1.  Your fan may include blade grommets. If your fan has grommets, 

insert them by hand into the holes on the blades. 

6-2.  Attach each blade to a blade iron using three blade assembly 

screws. If you used grommets, the blades may appear slightly loose 
after screws are tightened. Th

 is is normal.

6-3.  Remove the blade mounting screws and rubber shipping bumpers 

from the motor. Note: Some blade mounting screws are installed 
in the motor to secure shipping blocks.

6-4.  For each blade, insert one blade mounting screw through the 

blade iron, and attach lightly to the fan. Insert the second blade 
mounting screw, then securely tighten both mounting screws.

Blade Assembly

 Screws

Use with grommet

Use without grommet

Grommet

Blade 

Mounting 

Screw