ONKYO TX-SR804E Manual Do Utilizador

67

Adjusting the Listening Modes—Continued

You can adjust the bass and treble for the front speakers.
The tone control circuits are bypassed in the Direct and 
Pure Audio listening modes.

■ Bass
You can boost or cut low-frequency sounds output by the 
front speakers from –10 dB to +10 dB in 1 dB steps.

■ Treble
You can boost or cut high-frequency sounds output by 
the front speakers from –10 dB to +10 dB in 1 dB steps.

Notes:
• The AV receiver’s TONE buttons cannot be used in the 

Direct and Pure Audio listening modes.

• The tone control settings do not apply to the THX lis-

tening modes.

These settings only apply to 2-channel (stereo) sources.

■ Panorama
With this setting, you can broaden the width of the front 
stereo image when using the Pro Logic II Music or Pro 
Logic IIx Music listening mode.

On: Panorama function on.

Off: Panorama function off (default).

■ Dimension
With this setting, you can move the sound field forward 
or backward when using the Pro Logic II Music or Pro 
Logic IIx Music listening mode. The default value is 3. 
Higher settings move the sound field forward. Lower set-
tings move it backward. It can be adjusted from 0 to 6.
If the stereo image feels too wide, or there’s too much 
surround sound, move the sound field forward to 
improve the balance. Conversely, if the stereo image 
feels like it’s in mono, or there’s not enough surround 
sound, move it backward.

■ Center Width
With this setting, you can adjust the width of the sound 
from the center speaker when using the Pro Logic II 
Music or Pro Logic IIx Music listening mode. Normally 
if you’re using a center speaker, the center channel sound 
is output by only the center speaker. (If you’re not using 
a center speaker, the center channel sound will be distrib-
uted to the front left and right speakers to create a phan-
tom center). This setting adjusts the front left, right, and 
center mix, allowing you to adjust the weight of the cen-
ter channel sound. It can be adjusted from 0 to 7 (default 
value is 3).

■ Center Image
The DTS Neo:6 Music listening mode creates 6-channel 
surround sound from 2-channel (stereo) sources. With 
this setting, you can specify by how much the front left 
and right channel output is attenuated in order to create 
the center channel. It can be adjusted from 0 to 5 (default 
value is 3). This setting is unavailable if no surround 
speakers are connected.
When set to 0, the front left and right channel output is 
attenuated by half (–6 dB), giving the impression that the 
sound is located centrally. This setting works well when 
the listening position is considerably off center. When 
set to 5, the front left and right channels are not attenu-
ated, maintaining the original stereo balance.