ONKYO TX-SR876 Manual Do Utilizador

63

For AM tuning to work properly, you must specify the 
AM frequency step used in your area. Note that when 
this setting is changed, all radio presets are deleted.

Note:
This procedure can also be performed on the AV receiver 
by using its [SETUP] button, arrow buttons, and 
[ENTER] button.

If you connect an 

u-capable Onkyo MiniDisc 

recorder, CD recorder, or RI Dock to the TAPE IN/OUT 
jacks, or connect an RI Dock to the AUX 1 jacks, for 

u 

to work properly, you must change this setting.

This setting can only be changed on the AV receiver.

Note:
DOCK can be selected for the TAPE input selector or 
AUX 1 input selector, but not both at the same time.

Press the [RECEIVER] button, 
followed by the [SETUP] button.
The main menu appears onscreen.

q]/[w] but-

tons to select “7. Hardware 
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.

q]/[w] but-

tons to select “3. Tuner”, and 
then press [ENTER].
The “Tuner” menu appears.

q]/[w] but-

e]/[r] buttons to select:

10kHz: Select if 10 kHz steps are 

used in your area.

9kHz: Select if 9 kHz steps are used 

in your area.

Press the [SETUP] button.
Setup closes.

or

(3 seconds)

or

(3 seconds)

Press and hold down the [TAPE] 
or [AUX 1] input selector button 
(about 3 seconds) to change the 
setting.
Repeat this step to select MD, CDR, or 
DOCK.

For the TAPE input selector, the setting 
changes in this order: 

For the AUX 1 input selector, the set-
ting changes in this order: AUX1 

↔

 

DOCK

TAPE 

→

 MD 

→

 CDR

DOCK

→

 

→