ONKYO TX-SR876 Manual Do Utilizador

61

If the impedance of any speaker is 4 ohms or more but 
less than 6, set the Speaker Impedance to 4 ohms.

To use bi-amping or bridging, you must change the 
“Speaker Type” setting. For hookup information, see 
pages 27–30.

Notes:
• When bridging is used, the AV receiver is able to drive 

up to 5.1 speakers in the main room.

• When bi-amping is used, the AV receiver is able to 

drive up to 5.1 speakers in the main room.

• Before you change these settings, turn down the vol-

ume.

The onscreen menus shown in this manual may be 
slightly different from what you see on your TV.

Press the [RECEIVER] button, 
followed by the [SETUP] button.
The main menu appears onscreen.

If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “2. Speaker 
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

-

If you change these settings, you must run the auto-
matic speaker setup again (see page 64).

q]/[w] but-

tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.

q]/[w] but-

e]/[r] buttons to select:

4ohms: Select if the impedance of any 

speaker is 4 ohms or more but 
less than 6.

6ohms: Select if the impedances of all 

speakers are between 6 and 
16 ohms.

q]/[w] but-

e]/[r] buttons to select:

Select this if you’ve connected your 
front Speakers A normally.

Select this if you’ve connected your 
front Speakers A for bi-amped 
operation.

Select this if you’ve connected your 
front Speakers A for bridged opera-
tion. The BTL indicator will appear 
on the display.

Note:
“Bi-Amp” and “BTL” cannot be 
selected if “Front(Speaker B)” is set to 
“Bi-Amp” or “BTL”.