ONKYO TX-SR876 Manual Do Utilizador

95

This section explains items on the “Speaker Setup” 
menu.

Some of the speaker settings are set automatically by the 
Automatic Speaker Setup function (see page 64).

With the Speaker Configuration settings, you can specify 
which speakers are connected and a crossover frequency, 
distance, and level for each speaker. 

You can choose which of the speakers you want to use 
with the Speakers A and Speakers B configurations, and 
set the crossover frequencies, distances, and levels of the 
front Speakers A and front Speakers B independently. 
The other speakers (i.e., subwoofer, center, surround, 
and surround back) use the same crossover frequencies, 
distances, and levels for Speakers A and Speakers B.

The following crossover frequencies can be specified: 
Full Band, 40 Hz, 50 Hz, 60 Hz, 70 Hz, 80 Hz (THX), 
90 Hz, 100 Hz, 110 Hz, 120 Hz, 130 Hz, 150 Hz, or 
200 Hz.

Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers 
with a good sized woofer. For smaller speakers, specify 
a crossover frequency. Sounds below the crossover fre-
quency will then be output by the subwoofer instead of 
the speaker. Refer to your speakers’ manuals to deter-
mine the optimum crossover frequencies.

If you’re using THX-certified speakers, specify 
80 Hz (THX) for all speakers.

*TX-NR906 only

These settings are set automatically by the Automatic 
Speaker Setup function (see page 64).

Note:
• Speakers B cannot be selected if 

“Speaker Type: Front(Speaker B)” is 
set to “Not Use”.

• TX-SR876 continue with step 2 after 

press the [RECEIVER] REMOTE 
MODE button.

Press the [SETUP] button.
The main menu appears onscreen.

q]/[w] but-

tons to select “2. Speaker 
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

q]/[w] but-

tons to select “2. Speaker Con-
fig”, and then press [ENTER].
The “Speaker Config” screen appears.