ONKYO TX-SR876 Manual Do Utilizador

97

With this setting, you can specify the cutoff frequency of 
the LFE channel’s low-pass filter (LPF), which can be 
used to filter out unwanted hum. The LPF only applies to 
sources that use the LFE channel.

*If you’re using THX-certified speakers, select 
“80Hz(THX)”.

With this setting, you can boost bass output by feeding 
front left and right channel bass sounds to the subwoofer.

This setting can only be made if the “Subwoofer” setting 
in step 4 is set to “Yes”, and the “Front” setting in step 5 
is set to “Full Band”.

*If you’re using THX-certified speakers, select 
“Off(THX)”.

q]/[w] but-

e]/[r] buttons to select a low-

pass filter frequency. 
The following low-pass filter frequen-
cies can be selected: “80Hz(THX)”, 
“90Hz”, “100Hz”, “110Hz”, or 
“120Hz”.

Note:
The same setting is used for Speakers A 
and Speakers B.

Continue with step 12 in the next col-
umn.

This setting is not set automatically by the Automatic 
Speaker Setup function (see page 64).

q]/[w] but-

e]/[r] buttons to select:

The subwoofer only outputs the 
LFE channel.

In addition to LFE channel sounds, 
the subwoofer outputs front left and 
right channel bass sounds.

Note:
• The same setting is used for Speakers 

A and Speakers B.

Continue with step 13 on the next page 
(TX-NR906 only).

TX-SR876 continue with step 18 on 
page 99.

This setting is not set automatically by the Automatic 
Speaker Setup function (see page 64).