ONKYO TXNR828 Manual Do Utilizador

Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV 
receiver is connected.

a, and connect it to the 

The speaker setting menu appears.

• The on-screen menus appear only on a TV that is 

connected to HDMI OUT MAIN. If your TV is 
connected to other video outputs, use the AV 
receiver’s display when changing settings.

Perform the “2. Speaker Setup” according to your 
speaker configuration:

– Speakers Type(Front) (

)

– Powered Zone 2 (

)

– Subwoofer (

)

If you use a powered subwoofer(s), go to step 4. 
If not, go to step 5.

Speaker setup microphone

SETUP MIC jack

Adjust the subwoofer volume level to 75 dB, 
and then press ENTER.
Test tones are played through the subwoofer. 
Use the volume control on the subwoofer.

• If your subwoofer does not have a volume control, 

disregard the displayed level and press ENTER to 
proceed to the next step.

• If you set the subwoofer’s volume control to its 

maximum and the level displayed is lower than 75 dB, 
leave the subwoofer’s volume control at its maximum 
and press ENTER to proceed to the next step.

q/w to select “Audyssey Quick Start” or 

Press ENTER.
Audyssey MultEQ

®

 Room Correction and 

Speaker Setup starts.
Test tones are played through each speaker as 
Audyssey MultEQ Room Correction and Speaker 
Setup runs. This process takes a few minutes. 
Please refrain from talking during 
measurements and do not stand between 
speakers and the microphone.
Do not disconnect the speaker setup microphone 
during Audyssey MultEQ Room Correction and 
Speaker Setup, unless you want to cancel the 
setup.
If you select “Audyssey Quick Start”, you will go 
to step 9.

Place the speaker setup microphone at the 
next position, and then press ENTER.
Audyssey MultEQ performs more 
measurements. This takes a few minutes.

q/w to select an option, and then press 

The options are:

`

Save: 

Save the calculated settings and exit 
Audyssey MultEQ Room Correction and 
Speaker Setup.

`

Cancel: 

Cancel Audyssey MultEQ Room Correction 
and Speaker Setup.

• You can view the calculated settings for the speaker 

configuration, speaker distances, and speaker levels 

by using 

e/r.

q/w to select a target, and use e/r to 

change the setting.
After the results of Audyssey MultEQ have been 
saved, the menu will display the “Audyssey” 
(

), “Dynamic EQ” (

) settings.

• When “Audyssey Quick Start” has been used for 

measurement, “Audyssey” cannot be selected.

• These settings are applied to all input selectors.