ONKYO TXNR828 Manual Do Utilizador

• You can cancel Audyssey MultEQ

®

 Room Correction and 

Speaker Setup at any point in this procedure simply by 
disconnecting the setup microphone.

• Do not connect or disconnect any speakers during 

Audyssey MultEQ Room Correction and Speaker Setup.

• If the AV receiver is muted, it will be unmuted automatically 

when Audyssey MultEQ Room Correction and Speaker 
Setup starts.

• Changes to the room after Audyssey MultEQ Room 

Correction and Speaker Setup requires you run 
Audyssey MultEQ Room Correction and Speaker Setup 
again, as room EQ characteristics may have changed.

While Audyssey MultEQ Room Correction and 
Speaker Setup is in progress, one of the error 
messages below may appear.

 

The options are:

`

Retry:

Try again.

`

Cancel:

Cancel Audyssey MultEQ Room Correction and 
Speaker Setup.

The background noise is too loud. Remove the 
source of the noise and try again.

The number of speakers detected was different 
from that of the first measurement. Check the 
speaker connection.

This message appears if saving fails. Try saving 
again. If this message appears after 2 or 3 
attempts, contact your Onkyo dealer.

This message appears if a speaker is not detected. 
“No” means that no speaker was detected.

• See “Speaker Configuration” for appropriate settings 

(

• Please note that THX recommends any THX main 

speakers be set to “80Hz(THX)”. If you set up your 
speakers using Audyssey MultEQ Room Correction and 
Speaker Setup, please make sure manually that any THX 
speakers are set to “80Hz(THX)” crossover (

).

• Sometimes due to the electrical complexities of subwoofers 

and the interaction with the room, THX recommends setting 
the level and the distance of the subwoofer manually.

• Sometimes due to interaction with the room, you may 

notice irregular results when setting the level and/or 
distance of the main speakers. If this happens, THX 
recommends setting them manually.

If you’re using a powered subwoofer and it outputs 
very low-frequency sound at a low volume level, it 
may not be detected by Audyssey MultEQ Room 
Correction and Speaker Setup.
If the “Subwoofer” appears on the “Review Speaker 
Configuration” screen as “No”, increase the 
subwoofer’s volume to the half-way point, set it to its 
highest crossover frequency, and then try running 
Audyssey MultEQ Room Correction and Speaker 
Setup again. Note that if the volume is set too high 
and the sound distorts, detection issues may occur, 
so use an appropriate volume level. If the subwoofer 
has a low-pass filter switch, set it to Off or Direct. 
Refer to your subwoofer’s instruction manual for 
details.

Error message

The setup of the speaker can be done manually 
(

The setup of the volume level of each speaker also 
can be done manually (

).