ONKYO TX-SA705 Manual Do Utilizador
97
Advanced Setup—Continued
The digital input signal formats are available only for the
input sources that you have assigned a digital input jack;
otherwise you will see “Analog” indicated on the screen
(see page 51).
Normally, the AV receiver/AV amplifier detects the sig-
nal format automatically. However, if you experience
either of the following issues when playing PCM or DTS
material, you can manually set the signal format to PCM
or DTS:
• If the beginnings of tracks from a PCM source are cut
input sources that you have assigned a digital input jack;
otherwise you will see “Analog” indicated on the screen
(see page 51).
Normally, the AV receiver/AV amplifier detects the sig-
nal format automatically. However, if you experience
either of the following issues when playing PCM or DTS
material, you can manually set the signal format to PCM
or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
Lock Setup
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
]/[
]
buttons to select “8. Lock Setup,”
and then press [ENTER].
The Lock Setup menu appears.
and then press [ENTER].
The Lock Setup menu appears.
With this preference, you can protect
your settings by locking the setup
menus.
When the setup menus are locked, you
cannot change any setting.
your settings by locking the setup
menus.
When the setup menus are locked, you
cannot change any setting.
Locked: Setup menus locked.
Unlocked: Setup menus not locked.
ENTER
ENTER
8. Lock Setup
Lock Unlocked
Digital Input Signal Formats
1
Press and hold the AV receiver/AV ampli-
fier’s [DIGITAL INPUT] button for about 3
seconds.
fier’s [DIGITAL INPUT] button for about 3
seconds.
2
While “Auto” is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automat-
ically. If no digital input signal is present, the cor-
responding analog input is used instead.
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automat-
ically. If no digital input signal is present, the cor-
responding analog input is used instead.
DIGITAL INPUT