IBM 21Y Manual Do Utilizador
Diagnostics
23
PCNTNW-
NW-086
NW-086
The driver parameter block is too
small.
small.
Explanation: The driver parameter block
is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
PCNTNW-
NW-087
NW-087
The media parameter block is too
small.
small.
Explanation: The driver media
parameter block is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
parameter block is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
PCNTNW-
NW-091
NW-091
The hardware configuration conflicts.
Explanation: You tried to load a new
frame type for the existing controller. The
hardware assumptions made in doing so
are incorrect. This error can also occur if
you try to specify a mode (such as,
redundancy) that conflicts with another
specified mode.
Action: Make sure that the hardware
configuration matches the software
settings.
frame type for the existing controller. The
hardware assumptions made in doing so
are incorrect. This error can also occur if
you try to specify a mode (such as,
redundancy) that conflicts with another
specified mode.
Action: Make sure that the hardware
configuration matches the software
settings.
PCNTNW-
NW-126
NW-126
The group bit in the node address
override was cleared.
override was cleared.
Explanation: The IEEE address has a
group bit that indicates that an address
belongs to a group of stations. This bit is
used only as a destination address; it
cannot be used as a source address. You
tried to enter a source address with this bit
set. The driver cleared the group bit of the
source address.
Action: None necessary, message is for
information only.
group bit that indicates that an address
belongs to a group of stations. This bit is
used only as a destination address; it
cannot be used as a source address. You
tried to enter a source address with this bit
set. The driver cleared the group bit of the
source address.
Action: None necessary, message is for
information only.
Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
messages for the Ethernet controller