Yamaha 02R96 Manual Do Utilizador

Chapter 7—Input Channels

Each Input Channel can be routed to the Bus Outs, Stereo Out, or its own Direct Out.

Use the [1–8], [STEREO], and [DIRECT] buttons to route the 
currently selected Input Channel.
[1–8]: These buttons route the currently selected Input Channel to the 
Bus Outs.

[STEREO]: This button routes the currently selected Input Channel to 
the Stereo Out.

DIRECT: This button routes the currently selected Input Channel to its Direct Out.
[FOLLOW PAN]: This determines whether the Input Channel’s Pan control setting is 
applied to the Bus Outs. When off, the levels of the signals fed to the odd and even Bus Outs 
is the same. When on, the levels of the signals fed to the odd and even Bus Outs follows the 
Pan control.

Input Channel routing settings can be viewed and set on the Routing pages. If the Auto 
ROUTING Display preference is on, these pages appear automatically when a button in the 
SELECTED CHANNEL ROUTING section is pressed. See “Auto ROUTING Display” on 
page 197.

The Routing parameters for the 56 Input Channels are divided among three pages. The 
Input Channel 1–24 Routing page is shown below. The layout of the other two pages is the 
same.

Channels can also be selected by using the LAYER buttons and [SEL] buttons.

ALL STEREO: This button assigns all Input Channels to the Stereo Out.
ALL BUS: This button assigns all Input Channels to all Bus Outs
ALL CLEAR: This button clears all routing assignments.