Yamaha 02R96 Manual Do Utilizador
Panning Input Channels
67
02R96—Owner’s Manual
The currently selected Surround mode is displayed in the lower-left corner. When Stereo
mode is selected, the Bus Out routing buttons display numbers from 1 through 8. When a
Surround Pan mode is selected, they display abbreviations of the Surround Channel names,
as shown in the following table. See “Using Surround Pan” on page 69 for more informa-
tion.
mode is selected, the Bus Out routing buttons display numbers from 1 through 8. When a
Surround Pan mode is selected, they display abbreviations of the Surround Channel names,
as shown in the following table. See “Using Surround Pan” on page 69 for more informa-
tion.
Panning Input Channels
Input Channels can be panned between the left and right channels of the Stereo Out.
Using the Encoders
1
Use the LAYER buttons to select the Layers.
2
Press the ENCODER MODE [PAN] button to select the Pan Encoder
mode.
mode.
3
Use the Encoders to pan the input channels.
Using the SELECTED CHANNEL PAN/SURROUND Controls
1
Use the LAYER buttons to select the Layers, and use the [SEL] buttons to
select the Input Channels.
select the Input Channels.
2
Use the Pan control to pan the currently selected Input Channel.
The pan display indicates the pan position of the currently selected Input Channel. When
pan is set to center, the center two segments light up. You can use the [L] and [R] buttons
to select horizontal or vertical Input Channel partners.
pan is set to center, the center two segments light up. You can use the [L] and [R] buttons
to select horizontal or vertical Input Channel partners.
The [LINK] button, which is enabled only when a Surround mode other than Stereo is
selected, is used to link the Pan control and the Joystick so that either control can be used
for panning. It’s a global setting that applies to all Input Channels. For this to work, the
[EFFECT] button indicator must be off and the [GRAB] and [LINK] button indicators
must be on.
selected, is used to link the Pan control and the Joystick so that either control can be used
for panning. It’s a global setting that applies to all Input Channels. For this to work, the
[EFFECT] button indicator must be off and the [GRAB] and [LINK] button indicators
must be on.
Surround Mode
Bus Outs
1
2
3
4
5
6
7
8
Stereo
1
2
3
4
5
6
7
8
3-1
L
R
C
S
5
6
7
8
5.1
L
R
Ls
Rs
C
E
1
1. Short for LFE (Low frequency Effects).
7
8
LINK
GRAB
EFFECT
L
EVEN
R
L
R
PAN / SURROUND
DISPLAY
ODD