APC ACRC103 Manual Do Utilizador

Power cords may be routed through the top of the equipment (standard) or through the bottom (optional).

1. Route power cords 

through the 
equipment to the top 
power cord access, 
as shown.

2. Push the power cords 

through the hole at 
the top power cord 
entrance.

3. Secure the plate to 

the underside of the 
equipment top with 
four Phillips screws 
(provided).

4. Secure the power 

cords at appropriate 
locations inside the 
equipment using the 
provided tie wraps.

1. Remove the blank plate from the bottom power cord entrance. Save the plate and the four Torx 

screws.

2. Route the power cords through the equipment to the bottom power cord access, as shown.
3. Feed the power cords through the hole at the bottom power cord entrance and secure the plate to 

the bottom of the equipment with the four Torx screws you saved in step 1.

4. Secure the blank plate to the top power entrance with four Phillips screws (provided).
5. Secure the power cords at appropriate locations inside the equipment using the provided wire 

ties.

The equipment is capable of receiving power through one of two separate feeds, feed 

A or feed B. Use the display interface to configure the unit to receive power through feed A, feed B, or 
both). If connected, feed B is the primary power input to the equipment by default; feed A is the backup 
power input. The equipment receives power through feed B regardless of whether feed A is receiving 
power. If power is removed from feed B, feed A takes over and supplies power to the equipment (if feed 
A is connected). Connect the feed A and feed B cables to individual, breaker-controlled branch circuits 
or to PDUs backed by separate Uninterruptible Power Supplies (UPS).

Note: Feed A and feed B must not use the same branch circuit, PDU, or UPS.

For more information on configuring power input feeds, see the InRow RC Operation and 
Maintenance manual.

na

15

81a