Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-324

reset spe-standby 

If the system technician presses 

HELP

 after entering "reset spe-standby" on a 

duplex SPE system, the following message will be displayed:

Enter standby SPE recovery level ’1’(WARM), ’2’(COLDII), 

’3’(COLDI), ’4’(REBOOT) or ’5’(EXT REBOOT)

If the specified level is invalid (not 1-5), the following message will be displayed:

System reset level invalid

If the standby SPE is not refreshed and the SPE Select switches are selecting the 
active SPE, the following message will be displayed:

Active SPE locked via select switches; 

Standby SPE memory not refreshed

If the standby SPE is not refreshed; the following message will be displayed:

Standby SPE memory not refreshed; use the

"refresh spe-standby" command

If the reset command is successful, the following message displays:

Command successfully completed

If the reset command is unsuccessful, the following message displays:

Standby SPE failed to reset with requested level;

check for STBY-SPE errors

If the standby is in the process of doing a software upgrade, then the following 
will be displayed:

Standby SPE upgrade in progress, command denied

3

Cold-1

4

Reboot

5

Extended Reboot