Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-649

test processor 

If the system technician presses 

HELP

 after entering "test processor" on a duplex 

SPE system the following message will be displayed:

Enter [cabinet(1)];carrier(A-B),

[’long’ or ’short’],

  [’repeat’(1-100) or ’clear’], [’schedule’]

For SPE duplex systems, if no carrier is entered on the command line, the 
following message will be displayed:

A carrier must be specified for duplex systems

For any system, if the length of the user entered parameter exceeds three (3), the 
following message will be displayed:

Entry invalid

On any system, if any cabinet other than "1" or "01" is specified, the following 
message will be displayed:

Only cabinet ’1’ may be specified for this command

If a carrier is entered which is not valid for the current system configuration (for 
example, anything other than "A" or "B" for SPE duplex and anything other than 
the ’a’ carrier for SPE simplex), the following message will be displayed:

Carrier out of range;

Enter ’a’ if SPE simplex, ’a’ or ’b’ if SPE duplex

If the standby SPE was specified, and it does not respond, the following 
message will be displayed:

Standby SPE not available;

for information use ’status system’

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

All maintenance resources busy; try again later