Toshiba E6581830 Manual Do Utilizador

 

E658130 

- 14 - 

 

Use parameter c120 to set station number of the inverter. 
Set this parameter within the range of 1 to 64. 

Title 

Function Description 

c120 

CC-Link station   
number selection 

1 to 64 

 

*Use different station numbers for different devices. (If different devices have the same station 
number, the communication cannot be performed properly.) 
 

･

  Set consecutive numbers for the station numbers. (Do not skip a number in sequence   

like "station number 1 - station number 2 - station number 4".)   

･

The station number does not have to match with the physical connection sequence. 

(There is no problem with having the physical connection sequence like "station 
number 1 - station number 3 - station number 4 - station number 2".) 

･

  One inverter occupies one station. (One remote device station) 

･

  "L.ERR" LED flickers if the setting is changed. When power is switched on again,   

reset by parameter (f899 = 1) or the RES signal is turned on, the setting value is   
reflected and the LED turns off. 

 

Set the transmission speed. (Refer to the manual for the CC-Link master module for   
details of transmission speed.) 

Title 

Function Description 

c121 

CC-Link baud rate selection

0: 156kbps 
1: 625kbps 
2: 2.5Mbps 
3: 5Mbps 
4: 10Mbps 

 
･

  "L.ERR" LED flickers if the setting is changed. When power is switched on again,   

reset by parameter (f899 = 1) or the RES signal is turned on, the setting value is   
reflected and the LED turns off.