Chief Manufacturing MSP-DUK9000 Manual Do Utilizador

Instruction Manual

MSP-DUK9000

7

PROJECTOR INTERFACE PLATE
ATTACHMENT PROCEDURES

Attach the bottom portion of the universal projector mount to the 
projector as follows.

1.

Loosen, but do not remove, acorn nuts securing arms of the 
universal projector mount (see Figure 5).

2.

Adjust front and back legs to mounting points. If there are only 
three mounting points, remove one leg from the mount.

3.

Adjust feet (rotate right to raise, left to lower), making sure to 
allow for proper air ventilation and the mount is level with the 
projector [some feet may need to be at different heights to keep 
the mount level (M3, M4, M5 and M6 screws and washers 
included)].

4.

If the mounting holes are closer than a five inch diameter, raise 
the feet all the way up so they will swing under the universal 
interface bracket.

5.

Determine proper screw size and depth (M3, M4, M5 and M6 
included) for projector mounting and correct washers (M3, 
M4, M5 and M6 included). If proper screw size is not included 
with this unit, you must purchase the proper attaching hard-
ware separately.

6.

Secure (loosely) back two legs of universal projector mount to 
the projector at mounting locations.

7.

Secure (loosely) front two legs of universal projector mount to 
the projector at mounting locations.

8.

Move the universal projector mount to the center of gravity of 
the projector.

9.

Make sure the threaded studs on the plate are square in relation 
to the front of the projector.

10. Tighten screws and acorn nuts securing the legs of the univer-

sal projector mount.

11. Tighten hex nuts on the threaded studs to secure inserts at 

proper positions. 

Figure 6.  Install the Projector Interface Plate on Your Projector  

Figure 5.  Projector Interface Plate to  

 Universal Ceiling Projector 

Mount Attachment