EIKI LC-WUL100L Manual Do Utilizador

This projector uses nominal input voltages of 100–240 V

AC and it automatically selects the correct input voltage.

It is designed to work with single-phase power systems

having a grounded neutral conductor. To reduce the risk of

electrical shock, do not plug into any other type of power

system.

If you are not sure of the type of power being supplied,

consult your authorized dealer or service center.

Connect the projector with all peripheral equipment before

turning on the projector.

Installation

NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side

AC Outlet side

To POWER CORD

CONNECTOR on

your projector.

Ground

To the AC Outlet.

(120 V AC)

For Continental Europe

For the U .S .A . and Canada

For the U .K .

To the AC Outlet.

(200–240 V AC)

To the AC Outlet.

(200–240 V AC)



Note:

Unplug the AC power cord when the projector is not in

use. When the projector is connected to an outlet with

AC power cord, it is in stand-by mode and consumes a

little electric power.

CAUTION

The AC outlet must be near this equipment and must be

easily accessible.

Basic Operation

Connecting the AC Power Cord

Connect the AC power cord (supplied)

to the projector.

Ground