EIKI LC-WUL100L Manual Do Utilizador

Connect the projector’s AC power cord into an AC

outlet. The LAMP indicator lights red and the POWER

indicator lights green.
Press the ON/STAND-BY button on the side control

or the ON button on the remote control. The LAMP

indicator dims and the cooling fans start to operate.

The preparation display appears on the screen and

the countdown starts.

The preparation display will disappear

after 30 seconds.

After the countdown, the input source that was

selected the last time and the Lamp control status icon

(see page 57) appear on the screen.

Selected Input Source and Lamp control

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.



Note:

• The Lamp replacement icon and the

Filter replacement or the Filter cartridge

replacement icon may appear on the

screen depending on the usage state of

the projector.

• When the filter cartridge replacement

icon keeps appearing on the screen

at turning on the projector for some

time and no action is taken to replace

the filter cartridge, the projector will be

automatically shut down in 3 minutes

after turning on to protect the projector.

(pp. 66-68, 81)

• When the Picture in Picture function is

set to

User 1-5, User 1-5, Input source,

Lamp control status, Lamp replacement

icon and Filter warning icon will appear

on the screen for 10 seconds.

Basic Operation

(See page 57 for Lamp control status.)

Lamp control status

If the projector is locked with a PIN code, PIN code

input dialog box will appear.



Note:

• When the Logo select function is set to

Off, the logo will

not be shown on the screen (p.52).

• When

Countdown off or Off is selected in the Display

function, the countdown will not be shown on the screen

(p.52).

• When the Input button function is set to

Mode 3, the

input signal will be searched automatically (p.51).

• If you press the ON/STAND-BY button on the side

control or the remote control during the countdown

period, you can skip the countdown and go to the normal

operations. In this case, however, the brightness of the

image needs some time to stabilize after turning on the

projector. The display may flicker after turning on the

lamp for the characteristics of the lamp. This is normal

operation and not a malfunction.

After the OK icon disappears, you can

operate the projector.

PIN Code Input Dialog Box



Note:

• If the PIN code number is not entered

within three minutes after the PIN code

dialog box appears, the projector will be

turned off automatically.

• The "1234" is set as the initial PIN code

at the factory.

Enter a PIN code

Use the Point ▲▼ buttons on the side control or Number

buttons on the remote control to enter a number.

When using side control

Use the Point ▲▼ buttons on the side control to select a

number. Press the Point ► button to fix the number and

move the red frame pointer to the next box. The number

changes to . Repeat this step to complete entering a

four-digit number. After entering the four-digit number,

move the pointer to “Set”. Press the SELECT button so

that you can start to operate the projector.
When using remote control
Press the Number buttons on the remote control to enter

a number (p.14). When you complete entering a four-digit

number, the pointer moves to “Set”. Press the SELECT

button so that you can start to operate the projector.
If you fix an incorrect number, use the Point ◄ button to

move the pointer to the number you want to correct, and

then enter the correct number.
If you entered an incorrect PIN code, “PIN code” and the

number () will turn red for a moment. Enter the

correct PIN code all over again.

Turning On the Projector

Input 1
RGB(PC analog)

http://www.eiki.com