EIKI LC-WUL100L Manual Do Utilizador

Turn off the projector and unplug the AC power cord. 

Let the projector cool for at least 45 minutes.
Loosen the screws and open the lamp cover. Loosen 

3 screws of the lamp and pull out the lamp by using 

the built in handle.

Replace the lamp with a new one. Make sure that the 

lamp is properly and fully inserted. 

Connect the AC power cord to the projector and turn 

on the projector.

Follow these steps to replace the lamp.



For continued safety, replace with a lamp  

of the same type. Do not drop the lamp 

or touch the glass bulb! The glass can 

shatter and may cause injury.

Allow a projector to cool for at least 45 minutes before 

you open the lamp cover. The inside of the projector can 

become very hot.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on 

the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The 

timing when the LAMP REPLACE indicator should light is depending on the lamp mode.

Lamp replacement icon



Close the lamp cover and secure the screw. 

Lamp

Handle

Lamp cover

Screw

New 

Lamp

When replacing the lamp because it has stopped 

illuminating, there is a possibility that the lamp may be 

broken.

If replacing the lamp of a projector which has been 

installed on the ceiling, you should always assume that 

the lamp is broken, and you should stand to the side of 

the lamp cover, not underneath it. Remove the lamp cover 

gently. Small pieces of glass may fall out when the lamp 

cover is opened.

If pieces of glass get into your eyes or mouth, seek 

medical advice immediately.

Screws

69