Citrix Systems 9.3 Manual Do Utilizador

Each appliance ships with a mounting rail kit that contains two rail assemblies, one for
the left side and the other for the right side of the appliance, and screws to attach the
rails. An assembly consists of an inner rail and a rack rail. The supplied rail kit is 28
inches long (38 inches extended). Contact your Citrix sales representative to order a
23-inch (33 inches extended) rail kit.

Note: The same rail kit is used for both square-hole and round-hole racks. See
"

hole racks.

To mount the appliance, you must first install the rails and then install the appliance in
the rack.

Perform the following tasks to mount the appliance:

w

Remove the inner rails from the rail assembly.

w

Attach the inner rails to the appliance.

w

Install the rack rails on the rack.

w

Install the appliance in the rack.

The appliance is shipped with rack-rail hardware. This hardware consists of two inner
rails that you attach to the appliance, one on each side, and a rack-rail assembly that
you attach to the rack. The following figure illustrates the steps involved in mounting
the Citrix NetScaler appliance to a rack.

1. Place the rail assembly on a flat surface.

2. Slide out the inner rail toward the front of the assembly.

3. Depress the latch until the inner rail comes all the way out of the rail assembly.

4. Repeat steps 1 through 3 to remove the second inner rail.

1. Position the right inner rail behind the handle on the right side of the appliance.

2. Align the holes on the rail with the corresponding holes on the side of the

appliance.

3. Attach the rail to the appliance with the provided screws: 4 per side for a 1U

appliance and 5 per side for a 2U appliance, as shown in the following figure.

Citrix NetScaler Hardware Installation and Setup Guide

77