Cal Flame Barbecue Grills & Carts Manual Do Utilizador

Página de 28
2009 Barbecue Grills and Carts
LTR20091038, Rev. A
Using 
Your Grill
www.calspas.com
12
Inspect the hose before using the grill. If there 
• 
is  excessive  abrasion  or  wear,  or  if  the  hose  is 
cut, it must be replaced prior to using the grill. If 
you need a replacement hose, contact your Cal 
Flame dealer.
Ensure  the  area  around  the  barbecue  is  clear 
• 
of flammable substances such as gasoline, yard 
debris, wood, etc.
Ensure  there  is  no  blockage  of  the  airflow 
• 
through  the  vent  space  located  below  the  face 
of the unit.
When using propane gas:
• 
Keep the special ventilation openings in 
the enclosure free and clear of debris .
If  connected  to  a  propane  cylinder, 
carefully  inspect  the  rubber  hose 
attached  to  the  regulator  before  each 
use .
Ensure the propane cylinder, regulator, 
and  rubber  hose  are  installed  in  a 
location  not  subject  to  heating  above 
125º F (51º C) .
Ensure the burner flames burn evenly along both 
• 
sides of each burner with a steady flame (mostly 
blue with yellow tipping). If burner flames are not 
normal, check the orifice and burner for insects 
or insect nests.
Ensure the in-line gas valve or gas cylinder valve 
• 
is always shut OFF when the barbecue is not in 
use.
Do not operate the side burner with its cover closed 
• 
or the back burner with its cover installed.
Electronically Lighting the Grill and 
Infrared Burners
Open the hood.
1. 
Keep your face as far away from the burners 
2. 
as possible.
Rapidly  rotate  the  burner  knob  counter 
3. 
clockwise past the light position to HIGH. You 
will hear a loud click as the electronic lighter 
produces a spark.
Listen for the sound of the gas igniting. If the 
4. 
burner  does  not  light  on  the  first  try,  repeat 
immediately.
If  the  burner  does  not  light  after  three 
5. 
attempts,  turn  the  control  knobs  to  the  OFF 
position. Wait five minutes until the gas clears 
before attempting to light it again.
Repeat the procedure or try the manual lighting 
6. 
procedure below.
Upon successful lighting, repeat the process on 
7. 
the other burners you wish to light.
To  shut  off  the  burners,  rotate  the  knob  and 
8. 
turn  to  OFF.  It  is  normal  to  hear  a  popping 
sound when the burners are turned off.
Lighting the Grill
Each time you light the grill, check the following:
Manually Lighting the Grill and 
Infrared Burners
WARNING:    Do  not  use  standard  matches  or 
cigarette  lighters  to  perform  match  lighting 
procedures.  Serious burns can occur and lighters 
can explode.
Open the hood.
1. 
If you have just attempted to light the burner, 
2. 
allow five minutes for any accumulated gas to 
dissipate.
Slide out the drip tray from the grill.
3. 
Keep your face as far away from the burners 
4. 
as possible.
Light and insert a long stem match, holding it 
5. 
near the burner ports.
Push in and turn the control knob just past the 
6. 
LIGHT position to HIGH.
Listen for the sound of the gas igniting. If the 
7. 
burner does not light after five seconds, turn 
the control knobs to the OFF position.  Wait five 
minutes until the gas clears before attempting 
to light it again.
If  the  burner  does  not  light  after  several 
8. 
attempts  see  Troubleshooting  Guide  in  the 
back of this manual.