GTO 12 Manual Do Utilizador

  GTO 4000XLS Instruction Manual © 01.10.12  

All GTO transmitters are set to a standard code at the 

factory and are ready to operate your GTO gate operator.  

For your safety and security, we strongly recommend that 

you replace the factory setting with your own personal 

setting.  Follow the directions below:
NOTE: If you have multiple transmitters, you should adjust 

all of them at this time.

[RB741/RB742/RB743].

Use a small phillips head screw driver to remove the 

transmitter cover.

Set the transmitter DIP switches using a small screwdriver. 

There are nine (9) switches; each can be placed in three 

different positions (+, 0, –). DO NOT set all the switches 

in the same position, such as all +, all 0, or all –. Once the

DIP switches have been reset, replace and close the access 

cover.
WARNING: No other adjustments should be made inside the 

transmitter.

Program the new setting into the control board:
 

A.  Press and hold transmitter button.

 

B.  Press and hold the LEARN RMT (Learn Remote)  

 

 

 

button on the control board until the alarm sounds.

 

C.  Release transmitter button. The new code is stored  

 

 

in control board memory.

 

D.  Release  the LEARN RMT (Learn Remote) button.

NOTE: If you have purchased additional transmitters, 

program the settings for all at this time. 

+

0

ECE

1 2 3 4 5 6 7 8 9 

LED

The Troubleshooting Wizard has 

detailed information this and other 

Installations.