GTO 12 Manual Do Utilizador

  GTO 4000XLS Instruction Manual © 01.10.12

DIP Switch Settings (MODES)
DIP Switch #1:   Soft Start/Stop
 

  ON– Soft start enabled (factory 

preset).

 

  OFF– Soft start disabled.

 

  The Soft Start/Stop feature slowly 

starts the gate as it begins to open 

and slows the gate as it comes 

to the closed position. This saves 

wear and tear on the gate and gate 

operator system.

DIP Switch #2:  Warning Buzzer
 

  ON– Buzzer warning enabled 

(factory preset).

 

  OFF– Buzzer warning disabled.

 

  The Warning Buzzer alerts 

you when the gate operator is 

beginning to either open or close 

the gate. It sounds for the first 2 

seconds in each direction. It also 

sounds a warning when the gate 

obstructs two times in one cycle. 

Switching this to OFF only disables 

the open and close warning not 

the obstruction warning.

DIP Switch #3:   Push/Pull-To-Open
 

  ON: Push-To-Open.

 

  OFF: Pull-To-Open (factory preset).

 

  If your gate opens into the 

property the DIP Switch is set to 

the OFF position (factory setting). 

If your gate opens out from the 

property the DIP Switch must be 

set to the ON position. NOTE: if 

you have a Push-to-Open gate 

application you will need a Push-

To-Open bracket (see Push-To-

Open Instructions on page 21).

DIP Switch #4:  Dual Operation
 

  ON– Second opens simultaneously 

with master.

 

  OFF– Second opens after master 

(factory preset).

 

  Note: Not applicable for single gate 

operator.