Snapper EMLP21501KWV Manual Do Utilizador

 

2.2.2.  ENGINE & BLADE 
(Primer Models) (Electric Start) 
When the ignition key is turned to “START”, the engine 
will not crank over and will not start unless the blade 
control is engaged! 
1.  Move engine speed control to the “Fast” (Rabbit) 
position. See Figure 2.4. 
2. Push primer button three times to start a cold 
engine.  NOTE: Do not use primer button to start 
warm engine. 
3.  Pull blade control against handle. 
4.  Turn key to the start position until engine starts.  
See Figure 2.4. 

 
NOTE: If after 5 seconds of cranking the engine does not 
start, release the key and attempt starting again after waiting 
for approximately 20 seconds. 

 
5.  After engine starts, allow a brief warm-up until 
engine runs smooth.  

 

 

 

 

1.  Open fuel valve located at the top rear of 
engine (Kawasaki engines). 
2.  Move engine speed control to the 
“CHOKE” position. See Figure 2.3. 
IMPORTANT: Stop the engine (and blade) by 
releasing blade control. 
3.  Pull blade control against handle. 
4.  Pull rope start handle to crank engine. 
5. After engine starts, move engine speed 
control to the “FAST” (Rabbit) position and 
allow a brief warm up until engine runs 
smooth. 
 

2.2.3.  PROPELLING MOWER  
1.  Move ground speed control to the desired speed 
position. See Figure 2.5. 
 
 

2.  Move wheel drive control against handle to 
engage wheel drive and propel mower forward.  
 
IMPORTANT: Forward motion of machine must be 
stopped before changing position of the ground speed 
control. See Figure 2.5. 
 

 
 
 
 
 
 
 
 
 
 
 
 
 

Stop engine and blade by releasing the blade 
control. Stop forward motion of mower by releasing 
the wheel drive control.  
 

The height of the mower handle can be adjusted as 
follows: 
1.  Loosen the lower nuts on each lower handle as 
shown in Figure 2.6. 

 

 

 

 
2.  Move upper mower handle up or down until the 
desired position is achieved. 
3.  Tighten the nuts on each lower handle bracket to 
maintain desired position. Torque nuts to 15 to 25 ft. 
lbs.