Snapper EMLP21501KWV Manual Do Utilizador

 

 

1.  Pull the cutting height adjusting handle outward 
and move to desired cutting height. See Figure 2.7. 

 
IMPORTANT:  DO NOT flex the cutting height adjusting 
handle outward beyond what is required to change cutting 
height. Pulling outward too far may cause damage to the 
handle. 
 
 
 

 

 
2.6  RECYCLING OPERATION  
Converting this mower to the recycling operation requires 
no tools. First, STOP engine. Raise discharge door 
located at rear of machine. Remove grass catcher. Insert 
recycling plug fully into discharge opening. Allow 
discharge door to close.  See Figure 2.8. 
 
NOTE: For best recycling results, cut up to a maximum of 
1/3 of grass blade length and recycle ONLY when grass is 
dry. 
 

1.  Set the cutting height at the highest cutting 
position. 
2.  Move engine speed control to “FAST” (Rabbit) 
position. 
3. Move ground speed control to slowest speed 
setting. 
4. Proceed mowing slowly. If grass is very dense, 
raise cutting height to improve recycling 
performance. 
 
 

 

1.  Follow WARNING statement found on this page. 
2. Lift discharge door located at the rear of 
machine. See Figure 2.9. 
3. Install grass catcher onto the rear of machine. 
Position the rod ends of catcher frame over the tabs 
located at the rear of deck. Release discharge door, 
which is spring loaded, onto top of grass catcher.